[. . . ] Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS 1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] After about one minute, reconnect the power cord and set the selector to CHARGE again. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This unit does not have dustproof, splash-proof or waterproof specifications. Insert the top of the connecting plate of the AC power adaptor into the top of the battery mounting surface of video equipment. Contents of the recording cannot be compensated if recording or playback is not made due to a malfunction of this unit. However, the original battery capacity can be recovered if you use the battery completely and charge it fully again. However, to provide maximum battery efficiency, the recommended temperature range when charging is +10 °C to +30 °C (+50 °F to +86 °F). While pressing the BATT release knob, slide the AC power adaptor in the opposite direction of the arrow. POWER lamp (green) Témoin POWER (vert) Lámpara de alimentación POWER (verde) POWER-Anzeige (grün) CHARGE lamp (orange) Témoin CHARGE (orange) Lámpara de carga CHARGE (anaranjada) CHARGE-Anzeige (orange) The unit is not disconnected from the AC power source as long as it is connected to the wall outlet, even if the set itself has been turned off. Before attaching the AC power adaptor to the video equipment, remove the battery pack from the AC power adaptor. [. . . ] When purchasing Sony video products, Sony recommends that you purchase accessories with this "GENUINE VIDEO ACCESSORIES" mark. If the CHARGE lamp lights up and goes out after a while, the battery is operating correctly*. [. . . ]